Effect of pyrolysis and oxidation characteristics on lauric acid and stearic acid dust explosion hazards

The effect of pyrolysis and oxidation characteristics on the explosion sensitivity and severity parameters, including the minimum ignition energy MIE, minimum ignition temperature MIT, minimum explosion concentration MEC, maximum explosion pressure P_max, maximum rate of pressure rise (dP/dt)_max and deflagration index K_st, of lauric acid and stearic acid dust clouds was experimentally investigated. A synchronous thermal analyser was used to test the particle thermal characteristics. The functional test apparatuses including the 1.2 L Hartmann-tube apparatus, modified Godbert-Greenwald furnace, and 20 L explosion apparatus were used to test the explosion parameters. The results indicated that the rapid and slow weight loss processes of lauric acid dust followed a one-dimensional diffusion model (D1 model) and a 1.5 order chemical reaction model (F1.5 model), respectively. In addition, the rapid and slow weight loss processes of stearic acid followed a 1.5 order chemical reaction model (F1.5 model) and a three-dimensional diffusion model (D3 model), respectively, and the corresponding average apparent activation energy E and pre-exponential factor A were larger than those of lauric acid. The stearic acid dust explosion had higher values of MIE and MIT, which were mainly dependent on the higher pyrolysis and oxidation temperatures and the larger apparent activation energy E determining the slower rate of chemical bond breakage during pyrolysis and oxidation. In contrast, the lauric acid dust explosion had a higher MEC related to a smaller pre-exponential factor A with a lower amount of released reaction heat and a lower heat release rate during pyrolysis and oxidation. Additionally, due to the competition regime of the higher oxidation reaction heat release and greater consumption of oxygen during explosion, the explosion pressure P_m of the stearic acid dust was larger in low concentration ranges and decayed to an even smaller pressure than with lauric acid when the concentration exceeded 500 g/m³. The rate of explosion pressure rise (dP/dt)_m of the stearic acid dust was always larger in the experimental concentration range. The stearic acid dust explosion possessed a higher P_max, (dP/dt)_max and K_st mainly because of a larger pre-exponential factor A related to more active sites participating in the pyrolysis and oxidation reaction. Consequently, the active chemical reaction occurred more violently, and the temperature and overpressure rose faster, indicating a higher explosion hazard class for stearic acid dust.     

Enhanced triallyl isocyanurate (TAIC) degradation through application of an O3/UV process: Performance optimization and degradation pathways

• UV/O₃ process had higher TAIC mineralization rate than O₃ process. • Four possible degradation pathways were proposed during TAIC degradation. • pH impacted oxidation processes with pH of 9 achieving maximum efficiency. • CO₃^2– negatively impacted TAIC degradation while HCO₃^– not. • Cl^– can be radicals scavenger only at high concentration (over 500 mg/L Cl^–). Triallyl isocyanurate (TAIC, C₁₂H₁₅N₃O₃) has featured in wastewater treatment as a refractory organic compound due to the significant production capability and negative environmental impact. TAIC degradation was enhanced when an ozone(O₃)/ultraviolet(UV) process was applied compared with the application of an independent O₃ process. Although 99% of TAIC could be degraded in 5 min during both processes, the O₃/UV process had a 70%mineralization rate that was much higher than that of the independent O₃ process (9%) in 30 min. Four possible degradation pathways were proposed based on the organic compounds of intermediate products identified during TAIC degradation through the application of independent O₃ and O₃/UV processes. pH impacted both the direct and indirect oxidation processes. Acidic and alkaline conditions preferred direct and indirect reactions respectively, with a pH of 9 achieving maximum Total Organic Carbon (TOC) removal. Both CO₃^2– and HCO₃^– decreased TOC removal, however only CO₃^2– negatively impacted TAIC degradation. Effects of Cl^– as a radical scavenger became more marked only at high concentrations (over 500 mg/L Cl^–). Particulate and suspended matter could hinder the transmission of ultraviolet light and reduce the production of HO· accordingly.     

响应面法优化预氧化强化混凝处理铁锰地下水

以KMnO_4为氧化剂,Al_2(SO_4)_3·18H_2O为混凝剂,含铁锰离子地下水为模拟用水,考察预氧化强化混凝法的效果。利用响应面设计试验,分析氧化剂投加量、混凝剂投加量和pH值对铁锰去除的交互作用。模型优化结果显示,在氧化剂投加量4.16 mg/L,混凝剂投加量263.68 mg/L,pH值为7.54的最佳工艺参数下,铁锰去除率分别可达98.22%和97.49%。     

石油化工企业含苯胺消防污水处理技术研究

针对石油化工企业含苯胺的消防污水,利用基于过氧化氢和氯化铁为氧化剂的深度氧化技术,通过氧化、絮凝、过滤和吸附对消防污水进行处理。实验确定氧化剂的投加量为理论投加量,氧化时间1.0h,消防污水pH值为6.86时,絮凝剂最佳使用浓度约为2%,消防污水中苯胺和COD去除率达到99.5%以上,达到了消防污水处理效果。     

300MW燃煤锅炉机组超细颗粒聚并器的实验研究

为了解决燃煤锅炉烟气中超细颗粒难以脱除的问题,基于流体动力学原理设计了一种超细颗粒聚并器,并在300 MW燃煤锅炉机组电除尘器的前置烟道中进行了实验研究。结果表明,聚并器内部存在超细颗粒之间以及超细颗粒与大颗粒之间的相互聚集行为,从而使超细颗粒数量显著减少。例如,对于粒径在2.65和10.48μm以下的颗粒,其体积比例在聚并器出口分别减少了56.7%和62.3%,在电除尘器出口的粉尘浓度减少了26.34 mg/Nm3,这表明,基于流体动力学原理的聚并器对超细颗粒的聚并作用明显,具有良好的应用前景。     

Sources of underground CO: Crushing and ambient temperature oxidation of coal

As a harmful gas in underground coal mine, CO seriously threatened the safety of miners. Currently, the spontaneous combustion of residual coal in goaf is generally considered as the main source of underground CO. CO gas is also widely used as an indicator gas in fire prediction in mines. However, high concentrations of CO are also detected in some mines without spontaneous combustion of coal. Therefore, in the paper, with four ranks of coal, we studied other two potential CO sources: crushing and oxidation at ambient temperature. The more completely crushed coal produces more CO. The concentration of generated CO is inversely proportional to moisture content in coal. Therefore, the addition of water can inhibit the generation process of CO during the crushing process of coal. Lignite with low metamorphic grade can be oxidized to produce CO at ambient temperature (25 °C), and anthracite with high coal rank can be only oxidized to produce CO at 60 °C. Infrared spectra indicated that the coal with rich aliphatic hydrocarbons and oxygen-containing functional groups are more susceptible to oxidation at room temperature. Moreover, the smaller particle size of coal is more beneficial to the oxidation at ambient temperature to generate CO. CO generation during coal oxidation is also closely related to the ventilation rate.     

负载型颗粒活性炭催化过硫酸钠氧化降解橙黄G

通过在颗粒活性炭(GAC)上负载氧化铁,并以此作为催化剂(Fe/GAC)在常温常压下催化过硫酸钠(PS)产生硫酸根自由基降解偶氮染料橙黄G.研究了体系pH、氧化剂浓度、催化剂浓度对橙黄G去除率的影响,并且对催化剂的重复使用性能进行了测试.结果表明,在Fe/GAC/PS体系中,[OG]0=0.2 mmol/L,[GAC] =1 g/L,[PS]0=2 mmol/L,降解2h后OG去除率为99％,且有较高的矿化率;随着氧化剂浓度和催化剂浓度的增加,OG的去除效率提高;催化剂有较好的重复使用性.利用扫描电镜(SEM)对催化剂进行了表征,可以看出在活性炭上成功负载氧化铁.利用化学分子探针竞争实验鉴定催化反应中的活性物种SO4-·和OH·.     

高效钙钛矿型H2-SCR催化剂的制备与研究

用溶胶凝胶法合成了3种不同B位的钙钛矿催化剂,同时用X射线衍射(XRD)、比表面积分析(BET)、扫描电镜(SEM)、程序升温化学吸附(TPR)4种手段对催化剂进行了物理化学表征.从经济性和实际性考虑,本研究使用了清洁无二次污染的H2作为SCR的还原剂,同时控制了H2的加入比例,在小NO/H2比(1∶1、1∶5、1∶10)情况下,考察了3种催化剂的催化效率.由于实际燃煤烟气中含有大量的O2,因此,同时考察了高O2(O2/NO=100∶1)的加入对氧化还原反应的影响.从考察结果我们得知,在NO/H2为1∶1时,LaCoO3和LaNiO3的催化活性优于LaMnO3,达到80％.而在高H2/NO比时,则是LaMnO3的催化活性最高,达95％以上.O2的加入对氧化还原反应影响较大,温度高于250℃时,O2出现竞争性反应,消耗了大部分的还原剂,使得NO脱除率降低,而在250℃以下,O2的影响较小.     

印染RO浓水深度处理及回用

采用Fenton-石灰苏打法耦合工艺对某印染厂印染反渗透(RO)浓水进行深度处理。通过实验研究了不同H2O2和Fe2+投加量、p H和反应时间对废水COD去除率的影响,以及不同石灰和碳酸钠投加量对废水硬度的脱除效果,出水回用于染色工段进行染色实验。结果表明,在p H=3.0,Fe2+投加量为1.5 mmol/L,H2O2投加量为3.75 mmol/L,反应时间为45 min,石灰和碳酸钠投加量分别为450 mg/L和1 000 mg/L的条件下,出水COD和硬度的去除率可分别达到73.9%和85.0%,耦合工艺出水水质符合该厂回用染色水标准,且减少了盐的使用,可实现印染RO浓水回用。     

船舶柴油机选择性催化还原积碳臭氧直接氧化再生

为解决船舶柴油机SCR催化剂积碳再生问题,提出了臭氧直接氧化再生的方法。实验用玻璃纤维无胶滤筒采集PM,然后在管式炉中用臭氧氧化滤筒中的PM,研究了温度和臭氧浓度对PM氧化的影响。实验表明,臭氧的最佳氧化温度窗口为200~240℃,PM氧化速度随臭氧浓度提高明显加快,PM氧化率可以达到92%以上。根据实验结果,提出了船舶柴油机SCR积碳O3低温再生技术方案。